Beinn 20 Small / Beinn 20 L / Beinn 24 / Beinn 26 S / Beinn 26 L
Wear
indicator
Wheels
Rim wear - Routinely check your bicycle rims for any wear. Our bikes
have an indicator line that runs the circumference of the rim. When this
becomes fl ush with the rest of the rim or disappears it is time to replace
the wheel. For new wheels contact our customer service team at 503
954 2410.
Rim trueness - Depending on the type of riding your child does,
your bikes wheels may become untrue or damaged when riding. This
means they will not spin straight and will wobble. To check this please
see step 3 Brakes. If for any reason they are untrue our wheels can
be easily repaired. Please contact our technical support team
at 503 954 2410 or email support@islabikes.com.
Hubs - Your hubs are fi tted with cup and cone bearings. Although
they are sealed, water and grit can enter your hubs and cause
premature wear. To prolong the life and keep them running smooth
and effi cient, we recommendvannual maintenance and re-greasing of
hub bearings.
E-mail: support@islabikes.com Telephone: 503 954 2410
The QR lever should start to feel tight at 90 degrees as you
close – if it is too tight or too loose you can adjust by holding lever
‘open’ again and turning nut.
Check front wheel is correctly installed by lifting the
handlebar and holding the wheel at the fork. Firmly push
from side to side. If there is no movement the wheel is fi tted
correctly.
c. Clamp the QR lever to fully ‘closed’ position towards
rear of bike.
To Next Page
Loading...
