iSmartAlarm Home Security System User Manual

Name: iSmartAlarm Home Security System
Brand: iSmartAlarm
Rating: 4 (1 reviews)

31 pages

To Next Page

To Previous Page

2. Replace the button battery with same type - CR2032.

3. LED ﬂashes red once when the battery is installed.

NOTE: Whenever removing and/or replacing batteries, you should wait

at least ten seconds before placing new batteries in the device. This

will allow the device residual power charge to cycle through.

Contact sensor:

1. Take off the battery compartment.

Questions and Answers:

Need help?

Do you have a question about the iSmartAlarm Home Security System and is the answer not in the manual?

General