iSmartAlarm Home Security System User Manual

LED statuses of contact sensors, motion sensors and
remote tags
1. Device is powered on: red LED flashes once.
2. Device has been successfully added to a network: red LED flashes
twice.
3. Device is working normally: red LED is off.
4. Device has been triggered: red LED flashes once.
5. Low battery: red LED flashes 3 times for every 3 seconds.
SOUND CONFIRMATIONS
1. Siren stays on when the system is set off or the Siren button is
clicked twice (in quick succession) on either App or a Remote Tag.
2. Arm/Home: 1 “beep” confirmation.
3. Disarm: 2 “beep” confirmations.
2. Replace the button battery with same type - CR2032.
3. LED flashes red once when the battery is installed.
NOTE: Whenever removing and/or replacing batteries, you should wait
at least ten seconds before placing new batteries in the device. This
will allow the device residual power charge to cycle through.
7

iSmartAlarm Home Security System Specifications

General

Brand	iSmartAlarm
Model	Home Security System
Category	Security System
Language	English