ISMOD NANO - Troubleshooting

7. TROUBLESHOOTING
Problemi
Mënyra e kontrollit
Check the remaining power
The device has not been
used for a long time
The button is damaged
The LED light indicator is damaged
Check if the remaining
battery capacity is low
Check if the needle of the
heating element is damaged
Mënyra e zgjidhjes
Clean the heating
chamber.
Clean the heating
chamber.
Adjust the buttoning
direction
Charge the device until
the charge is complete
The power is completely
consumed, the device
needs to be charged
Send it to your
local service center.
Send it to your
local service center.
Charge your
device immediately.
Send it to your
local service center.
A non-combustible
tobacco cartridge
cannot be inserted
into the heating
chamber.
Check for unburned tobacco
residue from previous cartridges
stuck in the heating chamber.
Check that the gap between the
non-combustible tobacco
cartridge holder and the heating
chamber is aligned and secured
correctly.
Check the alignment between the
protective cover and the device,
make sure that the hole for the
non-combustible tobacco cartridge
is in a commensurate position.
The holder for
non-combustible
tobacco cartridges
cannot be placed in
the device
The protective cover
cannot be closed
and fastened
properly
Unable to start the
device
The LED light
flashes with
occasional
vibrations
The LED light is
flashing