Copyright ©2005-2020 ISPRING WATER SYSTEMS, LLC. All rights reserved.
Product Specifications
Model FG15B-KS
Flow Rate
3 - 15 GPM
Peak Flow Rate
15 GPM
Minimum Working Pressure
25 psi
Maximum Working Pressure
80 psi
Operating Temperatures
40-100 ºF (4 - 38 ºC)
pH Range
6 - 11
First-time Use – Install Filters
1. Verify that the O-ring is properly seated inside the groove on top of the filter housing. A
light amount of food-grade, silicon jelly may be used to help the O-ring seal better if
desired but is not required.
2. The filter cartridges are preserved in shrink wrap.
Note the direction sign on the sticker prior to
removing the wrap.
3. When placing the filter cartridge into the housing,
make sure it is centered and the protruding knob at
the bottom of the housing fits securely in the filter’s
central hole.
4. Screw the housing, with filters attached, onto the cap,
which should also have a center knob which should be inserted into the center hole of
the filter cartridge. Turn the housing in a clockwise direction by hand, then use the
housing wrench to tighten it another 1/4 – 1/2 of a turn and ensure it is snug. Do not
over-tighten. This can cause leaks and make it difficult to unscrew the housing when
replacing filters.
5. Slowly turn on water main to fill the housing. After a few minutes, the sound of water
entering the system will stop. Check for leaks to verify the system is operating properly.
To Next Page
Loading...
Need help?
General
