Need help?Do you have a question about the Ispring WGB21B and is the answer not in the manual?
General| Brand | Ispring |
|---|---|
| Model | WGB21B |
| Category | Water Dispenser |
| Language | English |
Determine location, water flow, measure, cut, and smooth pipe ends for system installation.
Securely mount the filter bracket ensuring it is level and attach plumbing.
Install optional shutoff valves and pressure gauges on either side of the filter.
Connect the ground jumper wire if necessary for system safety.
Unwrap and insert cartridges into housings, hand-tighten, and snug with wrench.
Slowly turn on water, check for leaks, and flush system for 10 mins.
Steps to turn off water, relieve pressure, unscrew housing, and remove old filter.
Instructions for cleaning filter housings and caps with bleach and water.
Guide for inserting new cartridges and tightening the housing securely.
Procedure for flushing the system with cold water after cartridge replacement.
To Next Page
