ITech IT8615 - Page 70

Measurement Functions
Copyright © ITECH Electronic Co., Ltd. 61
CR Mode
Press [Set] and [CR] to enter CR Mode. Set the resistance value and start
loading in CR Mode. The metering interface and parameters are shown in the
following figure.
CP Mode
Press [Set] and [CP] to enter CP Mode. Set the resistance value and start
loading in CP Mode. The metering interface and parameters are shown in the
following figure.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com