ITech IT8625 User Manual

Programmable AC/DC
Electronic Load
User Manual for IT8600 Series
Model: IT8615/IT8615L/IT8616/IT8617/
IT8624/IT8625/IT8626/IT8627/IT8628
Version: V2.7
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 Specifications

General

Brand	ITech
Model	IT8625
Category	Test Equipment
Language	English

Summary

Introduction and Safety Information

Safety Notices (CAUTION, WARNING, NOTE)

Warnings and cautions for safe operation and hazard avoidance.

Quality Certification and Warranty Limitations

Safety Symbols and Precautions

Explanation of safety symbols and general operating precautions.

Chapter 1 Inspection and Installation

Connecting Power and Test Lines

Procedures and safety precautions for connecting power cord and test lines.

Chapter 2 Quick Start

Rear Panel Introduction and Power-on Self-test

Chapter 3 Basic Operations

Input Control, Key Lock, and Menu Configuration

Controlling load input, locking keys, and configuring system settings via the menu.

Switching Modes and Operating Modes

Setting load mode (AC/DC) and selecting operating modes (CC, CR, CP, CV).

Timing Mode, Data Recording, and Protection Functions

Parallel and Three-phase Functions

Connecting units in parallel and configuring three-phase operations.

Chapter 4 Load Functions

Load Function Overview and AC Load Functions

Overview of AC/DC loads and simulation in AC modes (CC, CR, CP).

AC Mode Settings (CF/PF) and CC Mode

AC CR, CP Modes, and DC Load Functions

DC Load Modes (CC, CV, CR, CP) and Short Circuit

Simulating DC loads and short circuits.

Chapter 5 Measurement Functions

Interface Introduction and Parameter Measurement (AC/DC Modes)

Chapter 6 Waveform Display Function

Setting Trigger Configuration

Chapter 7 Harmonic Measurement Function

Overview and Configuration Settings

Chapter 10 Technical Specifications

Main Technical Specifications

Detailed electrical and physical specifications for IT8615 and other models.