Need help?Do you have a question about the ITech IT8514B+ and is the answer not in the manual?
General| Model | IT8514B+ |
|---|---|
| Category | Test Equipment |
| Voltage Resolution | 1mV |
| Operating Mode | CC, CV |
| Interface | USB, RS232 |
| Protections | Over Voltage Protection (OVP), Over Current Protection (OCP), Over Temperature Protection (OTP) |
Defines hazard symbols like CAUTION, WARNING, and NOTE for user guidance.
Outlines steps and safety precautions for connecting the electronic load to the device under test.
Details the four primary operating modes: CC, CV, CR, and CW.
Describes the Constant Current mode, its I-V curve, and how to set current values.
Describes the Constant Voltage mode, its I-V curve, and how to set voltage values.
Describes the Constant Resistance mode, its I-V curve, and how to set resistance values.
Describes the Constant Power mode, its I-V curve, and how to set power values.
Describes how to create and execute complex sequences of load states for automated testing.
Introduces various test functions for evaluating DC sources and batteries.
Explains how to perform continuous, pulse, and toggled transient tests.
Details the Over Current Protection test procedure and parameters.
Details the Over Power Protection test procedure and parameters.
Guides on performing battery discharge tests with various stop conditions.
Details the various protection features like OVP, OCP, OPP, and OTP.
Details the steps for editing and configuring automatic test files in the IT8500+ mode.
Explains how to set up and establish communication between the load and a PC via serial or USB.
To Next Page
