ITech IT8811 User Manual

Programmable DC Electronic
Load
Series IT8800 User’s Manual
Model:IT8811/IT8812/IT8812B/IT8812C
Revision: V2.6
Via Acquanera, 29 22100 Como
tel. 031.526.566 (r.a.) fax 031.507.984
info@calpower.it www.calpower.it

ITech IT8811 Specifications

General

Brand	ITech
Model	IT8811
Category	Test Equipment
Language	English

Summary

Safety Precautions

Compliance Information

Chapter 1 Acceptance and Installation

1.1 Confirm Package Contents

Verifies all items received in the product package.

1.2 Installation Position

1.6 Connecting the DUT

Procedures for connecting the device under test (DUT).

1.7 Connecting the Power Line

Guidance on connecting the power source and selecting appropriate cables.

Chapter 2 Quick Start

2.7 Power-On Selftest

Chapter 3 Function and Features

3.1 Switching of Local/Remote Operation Modes

3.2 Constant-Status Operation Mode

Overview of the four constant operation modes (CC, CV, CR, CW).

3.2.1 Constant Current Operation Mode (CC)

Details on setting and operating the Constant Current mode.

3.2.2 Constant Voltage Operation Mode (CV)

Details on setting and operating the Constant Voltage mode.

3.2.3 Constant Resistance Operation Mode (CR)

Details on setting and operating the Constant Resistance mode.

3.2.4 Constant Power Operation Mode (CW)

Details on setting and operating the Constant Power mode.

3.7 Configuration Menu Function

3.8 Triggering Function

3.9 Dynamic Test Function

Performs tests by switching between two dynamic parameters.

3.9.1 Continuous Mode

3.9.2 Pulse Mode

3.9.3 Toggle Mode

3.10 OCP Test Function

Performs Overcurrent Protection (OCP) tests.

3.11 OPP Test Function

Performs Overpower Protection (OPP) tests.

3.12 Battery Discharge Test Function

Tests battery performance by controlled discharge.

3.13 CR-LED Test Function

3.14 Measurement of Voltage Rise Time

3.15 Configuration Save Function

3.17 Protective Function

Overview of OVP, OCP, OPP, and OTP protection mechanisms.

3.18 List Operation

3.19 Terminal Function of Rear Board

3.20 External Signal Control Interface

3.21 Auto Test Function

Configures and runs automated test sequences.

Chapter 4 Technical Specification

4.1 Specification

Detailed electrical and performance specifications for models.

Chapter 5 References of Load Communication Interfaces

5.1 RS232 Interface

5.2 USB Interface

5.3 GPIB Interface

Appendix