ITech IT8811 - Chapter 2 Quick Start

Quick Start
Copyright © ITECH Electronic Co., Ltd. 6
Chapter2 Quick Start
This Chapter will introduce power-on check steps of IT8800 Series to ensure
normal start-up and usage under initialization status of the load. Besides, to
facilitate usage, this part also displays the functions of front board, rear board
and keyboard keys as well as display functions of VFD (Vacuum Fluorescent
Display) to a quick view of load appearance, structure and key usage functions
before operation.
2.1 Brief Introduction
IT8800 Series is a single-input programmable DC electronic load. Built in with
RS232, USB and GPIB communication interfaces, this series of programmable
DC electronic load provides a multi-purpose solution to meet different design
and test requirements.
This Series delivers special functions and advantages at international level,
including:
 High-visibility vacuum fluorescent display (VFD)
 Dynamic mode: up to 25KHz
 Voltage measurement dissolution rate: up to 0.1 mV Current 0.01 mA (10
uA)
 Voltage and current measurement speed: up to 50 KHz
 Four operation modes: constant voltage, constant current, constant
resistance and constant power.
 Rotary coding switch for easy and quick operation
 Remote sense test function
 Battery test function
 OCP test, OPP test
 Auto test function
 CR-LED test
 Memory capacity: 100 groups
 Short-circuit function
 Dynamic test function
 Portable and robust enclosure equipped with skid resistant foot stand
 Intelligent fan control
 Built-in Buzzer, for warning
 Outage backup memory
 Built-in GPIB, USB and RS232 communication interfaces
Model
Voltage
Current
Power
IT8811
120V
30A
150W
IT8812
120V
30A
250W
IT8812B
500V
15A
200W
IT8812C
120V
60A
250W