ITech IT8811 - 3.2.1 Constant Current Operation Mode (CC)

Function and Features
Copyright © ITECH Electronic Co., Ltd. 13
Fig. 3-1 Voltage-Current Relation Schema under CC Mode
Under CC mode, the electronic load provides three ways to set constant
current.
 Rotate adjusting knob to set constant current value.
 Use numeric keys to input current value and press [Enter] key to
confirm set constant current value.
 Use
moving cursor and press to adjust values at
corresponding positions.
Operation steps
1. Press [CC] key and [Shift] +[CV] to enter parameter setting screen.
Constant Current
Range=0.000A
2. Set maximum working current value and press [Enter] for confirmation.
Constant Current
Range =1.000A
3. Set maximum voltage value and press [Enter] key.
Constant Current
High=0.00V
4. Set minimum voltage value and press [Enter] key.
Constant Current
Low=0.000V
5. Set high and low rate and press [Enter] key.
Constant Current
High-Rate Low-Rate
6. Set ascending slope and press [Enter] key.
Constant Current
Rise up=0.000A/uS
7. Set descending slope and press [Enter] key.
Constant Current
Rise down=0.000A/uS
8. Complete parameter setting.
10.0000V 0.0000A
0.00W CC=1.000A
Load voltage
I
V
Set current
CC mode
Load current