Measurement Functions
Copyright © ITECH Electronic Co., Ltd. 63
CP Mode
Press [Set] to enter the default CP Mode. Set the resistance and start loading in
CP Mode. The metering interface and parameters are shown in the following
figure.
CV Mode (Only for IT8615/IT8615L)
Press [Set] to enter the default CV Mode. Set the resistance and start loading in
CV Mode. The metering interface and parameters are shown in the following
figure.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
