5. The display shows >START<. Confirming by pressing OK, the
cycle begins automatically, executing in sequence:
RECOVER (with de-icing pause)
DISCHARGE OF EXHAUSTED OIL (it happens
automatically)
VACUUM (with leaking test “diagnosis”)
CHARGE OF NEW OIL (1…20)
CHARGE OF GAS (with sound alarm at end)
PRINT (choose YES or NOT if the station has a printer)
6. Charge operation is over. At this point, it is appropriate to
execute manually the pressures test, following the instructions
at paragraph 3.6. This operation cannot be executed
automatically.
7. Once the pressures test is finished, turn off the station and
remove the quick couplings from the car.
To Next Page
Loading...