iTechworld PS2000 - Advanced Modes and Accessories; UPS Mode Functionality; UPS Connection Diagram; Included Accessories

5
TV
UPS Mode
UPS Connections
The PS2000 has a bypass function, which means power will not
pass through the battery; it will be taken directly from the AC
output of your house.
In this mode, the power source is the power grid, when there is an
emergency power outage, the power source will switch to the
battery within 10ms and protect the connected application.
As shown in the figure below, connect the PS2000 between the
wall socket and the electrical appliances, ensuring the power of
the PS2000 is ON. When you turn on the electrical appliances,
power will be taken directly from the grid.
In this state, when the power grid is cut off, it will automatically
switch to the PS2000 internal battery to supply power.
Recommended to use 2x 200W or 2x 300W iTechworld solar blankets (not included)
·In UPS mode, the maximum power output is below 2000W
·In UPS mode, if the AC output exceeds 2000W, the AC output
icon “ ”will blink, indicating overload.
25A Anderson to 50A
Anderson Connector
Accessory List