SERVICE MANUAL
D-26
D.4 Filling and Checks
Warning: To drain and load the oil and to check the oil level the transmission must be horizontal.
Scheduled maintenance oil drain
To drain the oil remove the level plug (1) and the drain plug (2).
Danger: Risk of violent oil ejection, follow carefully all the safety procedures indicated in this manual and in the vehicle manual.
See: cap.B - SAFETY INSTRUCTIONS
Drain all oil. Clean the plug (2) and tighten it to the prescribed torque (sec.C.6).
Scheduled maintenance oil filling
Carry out the following instructions:
Fill the transmission with oil to the maximum level marked on the level dipstick (1). Apply the parking brake. Keep the speed control
in NEUTRAL range. Start the engine by keeping the slow running of 800-1000 rpm until an oil temperature higher than 25 °C is
obtained. Check that the transmission oil level is in the prescribed range on the level dipstick (1). If necessary, top up with oil to keep
the level in the prescribed range.
Scheduled maintenance oil level check
Use the oil level dipstick (1) to check the oil level.
Warning: If leakage or any other factor determining fall in the oil level is found, then it is advisable to check immediately, in order to
avoid damages to the mechanical parts.
POSITION
1
1
2
3
4
Descriptions (next figure)
Oil level dipstick(oil filling port)
Oil filling port
Oil drain port
Greaser
Brakes breather
ITL
To Next Page
Loading...