SERVICE MANUAL
E-2
D.1.1 Disassembly
Some of the following pictures may not show exactly your machine, but the
process is the same.
Remove the fastening screws (20).
Remove the cover (19).
Note: the cover is attached with sealant
Drain the oil completely from the transmission.
Unscrew the bolts (23) and remove the group.
Tap on the shaft end to release the transmission group bearings.
Note: it's advisable to use a soft hammer to do not damage the shaft.
Remove the fastening screws (13).
Disassemble the cover (14).
Note: the cover is attached with sealant.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
ITL
To Next Page
Loading...