SERVICE MANUAL
E-117
13. Assemble brake flange without brake assy. Tighten 5 screws (1).
See: fig.13.
14. Measure pinion-bevel gear crown backlash. The measured backlash value must be within the prescribed range: 0.10-
0.30 mm
See: fig.14.
Fig.13 Fig.14
15. Choose shims (11) and (10) among the range available.
Shims Range
Thickness - mm
Quantity
0.05
—
0.10
—
0.30
—
0.50
—
See: fig.15.
16. Adjust shims (11) and (10), remembering that:
[a] if the measured backlash is less than given tolerance range, increase shims (10) from the side opposite to bevel
gear crown and decrease shims (11) of the same measure;
[b] if the measured backlash is greater than given tolerance range, increase shims (11) from the side of bevel gear crown
and decrease shims (10) of the same measure.
See: fig.16.
Fig.15 Fig.16
ITL
To Next Page
Loading...