SERVICE MANUAL
E-119
18. If the measurement is not within the requested range, check the assembly of each component and operate on the shims (11)
and (10) remembering that:
[c] if the total preload is less than given range, increase shims (11) and (10) by same measure, keeping pinion-bevel
gear crown backlash value unchanged;
[d] if the total preload is greater than given range, decrease shims (11) and (10) by same measure, keeping pinion-bevel
gear crown backlash value unchanged.
See: fig.19.
19. Remove screws (1) and brake flange (2).
20. Fasten with screws differential support flange (4).
21. Assemble with tool 2 pins (3) using tool CA715815.
See: fig.20 and sec. E.1 (Gear box).
Fig.19 Fig.20
Fig.21 Fig.22
22. Remove screws.
See: fig.21.
23. Assemble preassembled brake (2).
See: fig.22.
ITL
To Next Page
Loading...