What should I do if the emergency button indicator light is blinking on Itm Trademaster WE-350DSA?
If the emergency button indicator light is blinking on your Itm Saw, check if the emergency switch is stuck. Also, check the wire connections (Wires No. 61, 66 in the emergency switch on saw body; wires No. 61, 65 for the emergency switch on the food pad control.)
What to check if the foot pad switch isn't working on Itm Trademaster WE-350DSA Saw?
If the foot pad switch isn't working on your Itm Saw, verify that the Hand/foot pad control operation selector (E) is properly switched. Check if the foot pad switch is in working order. Also, check the wire No. 61, 72 for OK signal.
What to do if the control panel of Itm Saw shows no operation?
If the control panel of your Itm Saw shows no operation, check DC24V and DC5V, and examine the related components for an overload or short-circuit. Also, check the switches to ensure each one is correctly positioned.
Why is the saw blade of Itm Trademaster WE-350DSA Saw reversing?
If the saw blade of your Itm Saw is reversing, check the wiring of motor phases on the blade motor M2.
What to do if the hydraulic pump of Itm Trademaster WE-350DSA works but with low pressure?
If the hydraulic pump of your Itm Saw is working but with low pressure, check the hydraulic motor M1 wiring for correct three phase connections. Also, check the hydraulic flow for normal condition, ensuring there is no staleness, shortage, or leaking.
Essential advice for safe operation and operator responsibilities.
Overview and identification of all control switches, buttons, and indicator lights.
Step-by-step guide on how to start and perform a cutting operation.
Method for properly tensioning the saw blade using the tension gauge.
Procedures for setting blade guide blocks for optimal cutting performance.
Instructions on how to safely remove and install a new saw blade.
How to adjust blade position on flywheels for proper contact and guidance.
Criteria and tables for choosing the appropriate blade based on material properties.
Factors influencing the selection of blade teeth pitch for optimal cutting.
Guidelines for setting correct cutting and feed speeds based on material and chips.
Troubleshooting guide for electrical faults and their remedies.
Diagnosis and solutions for common problems related to blade performance and cut quality.
To Next Page
General