6) Fit filter, injectors, and collector.
ATTENTION: IT IS VERY IMPORTANT, WHEN REPLACING THE MANIFOLD THAT THE
INJECTORS ARE COMPLETELY PERPENDICULAR TO THE SAME. IF THE CUBES AT THE
END ARE TWISTED, THEY CAN REMAIN WITHOUT WATER.
6.3.- CLEANING THE BINS
1) Disconnect the machine, close water faucet and empty storage bin of ice
2) Use the cleaner/water solution to clean all surfaces of the bin. Use a nylon brush or
cloth. Then rinse all areas thoroughly with clean water.
3) Use the sanitizer/water solution to sanitize all surfaces of the bin. Use a nylon brush or
cloth.
4) Rinse with plenty of water, dry, run the machine and open water faucet.
To Next Page
Loading...
