Why none of the electrical parts work in my ITV ICE MAKERS SPIKA Ice Maker?
If none of the electrical parts of your ITV ICE MAKERS Ice Maker are working, the machine might be unplugged. Plug in the machine and verify the socket has power.
Why is my ITV ICE MAKERS Ice Maker has low production?
If your ITV ICE MAKERS Ice Maker has low production, the condenser may be dirty. Clean the condenser and also check the incoming water and air temperature.
Why does my ITV ICE MAKERS SPIKA run and stop intermittently?
If your ITV ICE MAKERS Ice Maker runs and stops intermittently, the safety pressure switch may be opening. Clean the air condenser located behind the front grid.
Why does my ITV ICE MAKERS Ice Maker stop after running for a short time?
If your ITV ICE MAKERS Ice Maker stops after running for a short time, the safety pressure switch may be opening. Try cleaning the air condenser located at the back of the unit.
How to fix a non-uniform flow pattern at the evaporator of my ITV ICE MAKERS SPIKA Ice Maker?
If you notice a non-uniform flow pattern at the evaporator of your ITV ICE MAKERS Ice Maker, the distributor may be dirty or scaled. Perform a descaling procedure and then remove and clean the distributor by pulling it from the two clips on its sides.
What to do if rear switch is OFF in my ITV ICE MAKERS SPIKA?
Switch the rear switch to the ON position on your ITV ICE MAKERS Ice Maker.
What to do if bin thermostat open and ice touching bin tube in ITV ICE MAKERS SPIKA Ice Maker?
If the bin thermostat is open and ice is touching the bin tube in your ITV ICE MAKERS Ice Maker, remove the ice from the bin.
What to do if front switch position is 0 in my ITV ICE MAKERS Ice Maker?
Move the switch to the ICE position, which is located behind the front panel of your ITV ICE MAKERS Ice Maker.
Why is there no water in the tray of my ITV ICE MAKERS SPIKA Ice Maker?
If there's no water in the tray of your ITV ICE MAKERS Ice Maker, it could be due to a lack of incoming water. Check the water supply. Another possibility is a blocked inlet strainer at the water valve. Check and clean it.
What to do if it's difficult to release the ice slab at harvest in my ITV ICE MAKERS SPIKA?
If you find it difficult to release the ice slab at harvest in your ITV ICE MAKERS Ice Maker, the unit may be badly leveled, tilted to the back. Ensure the unit is level, lowering the front if necessary.
General| Brand | ITV ICE MAKERS |
|---|---|
| Model | SPIKA Series |
| Category | Ice Maker |
| Language | English |
To Next Page
