Why do all the electrical parts work, but not the compressor in my ITV ICE MAKERS SPIKA?
If all the electrical parts work, but the compressor doesn't in your ITV ICE MAKERS Ice Maker (and the water doesn't freeze), the front switch might be in the WASH position. Move it to the ICE position, which is located behind the front panel.
What to do if there is no water in the tray of my ITV ICE MAKERS Ice Maker?
If there is no water in the tray of your ITV ICE MAKERS Ice Maker, first check the water supply to ensure it is connected and functioning. If the water supply is okay, inspect the inlet strainer at the water valve for any blockages and clean it if necessary.
What to do if all electrical parts work but not compressor in my ITV ICE MAKERS Ice Maker?
If all electrical parts of your ITV ICE MAKERS Ice Maker are working except the compressor (and the water doesn't freeze), check if the compressor switch is in the “WASH” position (0). If so, switch it to the “ICE” position (1).
What to do if it's difficult to release the ice slab at harvest in my ITV ICE MAKERS SPIKA?
If you find it difficult to release the ice slab at harvest in your ITV ICE MAKERS Ice Maker, the unit may be badly leveled, tilted to the back. Ensure the unit is level, lowering the front if necessary.
Why is the ice slab empty or too thick in my ITV ICE MAKERS Ice Maker?
If the ice slab in your ITV ICE MAKERS Ice Maker is either empty or too thick, the thickness probe may be desadjusted or scaled. Adjust or clean the thickness probe.
What causes water to overflow the tray in my ITV ICE MAKERS Ice Maker?
If water overflows the tray in your ITV ICE MAKERS Ice Maker, the level probe may be too high or scaled. Adjust or clean the level probe.
Why is it difficult to release the ice slab at harvest in my ITV ICE MAKERS SPIKA?
If you are having difficulty releasing the ice slab at harvest time with your ITV ICE MAKERS Ice Maker, it could be due to the unit not being properly leveled, specifically tilted to the back. Level the unit, ensuring the front is slightly lower. Alternatively, there may not be enough harvest time. In that case, add more pins to the cam timer wheels, following the label indications.
What causes the ice slab to be empty or too thick in my ITV ICE MAKERS Ice Maker?
If the ice slab is either empty or too thick in your ITV ICE MAKERS Ice Maker, the cycle time may be improperly adjusted. Adjust the thermostat located in the electric box under the top cover.
How to fix a non-uniform flow pattern at the evaporator of my ITV ICE MAKERS SPIKA Ice Maker?
If you notice a non-uniform flow pattern at the evaporator of your ITV ICE MAKERS Ice Maker, the distributor may be dirty or scaled. Perform a descaling procedure and then remove and clean the distributor by pulling it from the two clips on its sides.
Why does my ITV ICE MAKERS Ice Maker stop after running for a short time?
If your ITV ICE MAKERS Ice Maker stops after running for a short time, the safety pressure switch may be opening. Try cleaning the air condenser located at the back of the unit.
General| Brand | ITV ICE MAKERS |
|---|---|
| Model | SPIKA Series |
| Category | Ice Maker |
| Language | English |
To Next Page
