M8 nuts (2)
1)
Disassemble gearbox (see previous sections)
2)
Disassemble plate/flange (see previous section)
3)
Remove top seals.
4)
Place and fix extracting ring.
5)
Strike chisel placed over extracting ring using nylon head hammer.
Assembly:
1)
Install new seals and lubricate (SHELL MULTIFAK EP2 TE code ITV420).
2)
Secure bearing.
3)
Mount plate.
IMPORTANT: Be careful not to damage seals. Lubricate seal lips with grease.
To Next Page
Loading...
