Ivation IVAPAC8KBTU User Manual

Hung Window Sliding Window
Windows Type
Window slider A Window slider B
Bolt
Window slider A
Window slider A
Portable Air Conditioner
QUICK START GUIDE
IVAPAC8KBTU
IVAPAC10KBTU
IIVAPAC12KBTU
Before installing your air conditioner, make sure that you have the following tools (not included):
• Medium Phillips screwdriver
• Tape measure or ruler
• Knife or scissors
1. Check to box and ensure that all parts are accounted for:
1. Unit adapter
2. Exhaust hose
3. Window slider adapter
4. Bolt
5. Window slider A
6. Window slider B
7. Adhesive foam seal A (2)
8. Adhesive foam seal B (2)
9. Foam seal C
10. Security bracket
11. Screws (2)
12. Drain hose
13. Remote controller with 2 AAA batteries
1
6
10 11 1312
789
2345
2. Check the window length and type
Measure the length of the window, then choose the slider that
will fit. If 2 sliders are needed, use the bolt to fasten them.
3. Prepare the exhaust hose assembly
Insert the exhaust hose into the window slider adapter and
unit adapter. Then clamp together with the elastic buckles
of the adapter.
Unit adapter Window slider
adapter
Exhaust hose
Exhaust hose
assembly

Ivation IVAPAC8KBTU Specifications

General

Cooling Capacity	8, 000 BTU
Type	Portable
Power Supply	115V/60Hz
Dehumidification	Yes
Fan Speeds	3
Remote Control	Yes
Programmable Timer	Yes
Refrigerant	R410A
Timer	24-hour
Warranty	1 Year Limited
Operating Temperature	64-90°F

Summary

Check Parts and Tools

Account for All Parts

Verify all listed parts are present before proceeding with installation.

Required Tools

Ensure you have a Phillips screwdriver, tape measure, and scissors available.

Window Preparation and Hose Assembly

Window Length and Type Check

Measure window length and select the appropriate slider; use bolt if two sliders are needed.

Exhaust Hose Assembly Preparation

Insert exhaust hose into adapters and secure with elastic buckles for proper connection.

Exhaust Hose and Window Sealing

Install Exhaust Hose Assembly

Connect exhaust hose to air outlet, aligning hook and inserting adapter into the lower groove.

Attach Foam Seals to Window

Cut adhesive foam seals A and B to size and affix to window sash and frame.

Insert Non-Adhesive Foam Seal

Cut foam seal C to window width and place between glass and frame.

Final Installation Steps

Install Security Bracket

Optionally, install the security bracket using the provided screws for added stability.

Insert Window Slider Adapter

Insert the window slider adapter into the designated hole of the window slider.