6
BASIC OPERATION
1. Follow these steps to insert the smaller end of the power cable into
the 12 V power input jack on the rear of the clock.
a. Position the cable end perpendicular to the backside of the
clock.
b. Push the cable end into the connection port, then slide the
cable to the right.
c. Turn the cable so that it lays flat against the backside of the
clock.
d. Thread the cable through the jagged groove to secure it.
2. Plug the other end of the cable into a standard wall outlet socket.
3. The display will automatically turn on and display the time and date.
IMPORTANT: When disconnecting your time bar, make sure to
disconnect the power cord from the input jack on the rear of the
clock before disconnecting it from the wall socket.
Manually Setting the Date and Time
To set the time on your digital time bar, follow these instructions:
1. While in normal time display mode, press the SET/ENTER button
to enter clock setting mode.
2. Use the number pad to enter the date in MM/DD/YYYY format.
Once you’ve finished entering the date, press SET/ENTER again.
3. Use the number pad to enter the time in HH:MM format, and use
the AM/PM button to switch between AM and PM if you’re using
the 12-hour time format. Press the SET/ENTER button again to
save and exit.
4. To exit the clock setting mode without saving, press the CLOCK
button at any time.
BASIC OPERATION
BASIC OPERATION
To Next Page
Loading...
Need help?
General
