IVEK DIGISPENSE 3009 - Page 65

DIGISPENSE 3009 CONTROLLER MODULE, STYLE B Page 3-65
29 October, 2019 IVEK Corp. P03R017E
3.4.7.14 System Info Screen
Keylock/Supervisor
D = Display P = Push-button Accessible I/O Test
C = Display/Change N = Not Accessible/Viewable Operator
0 SYSTEM INFO <— status —>
2
3 FIRMWARE VERSION = HT######
4 FIRMWARE CRC = ############
5 SERIAL NUMBER = ############
6
7 ASSERTS SW = ############
8 ASSERTS SW CODE = ################
9 ASSERTS HW = ################
10 ASSERTS HW CODE = ############
11
12 http://www.ivek.com
13
if NOT faulted
14 SETUP C CONTRAST
15 SCREEN ADJUST
OR if faulted
14 SETUP C FAULT CONTRAST
15 SCREEN SCREEN ADJUST
----- Displays the Controller Module Status ........ D D D
----- Displays the firmware version ...................... D D D
----- Displays the firmware CRC.......................... D D D
----- Displays the serial number .......................... D D D
----- Displays the asserts SW .............................. D D D
----- Displays the asserts SW code ..................... D D D
----- Displays the asserts HW.............................. D D D
----- Displays the asserts HW code ..................... D D D
The following screens are accessible from
this screen based on the system status.
Setup C ................................................................ P P P
Contrast Adjust .................................................... P P P
Fault ..................................................................... P P P