IVEK DIGISPENSE 3009 - Page 97

DIGISPENSE 3009 CONTROLLER MODULE, STYLE B Page 3-97
29 October, 2019 IVEK Corp. P03R017E
Default: 0.05
v => DISPENSE VOLUME
v or v0 v0,<value2> Returns the current number of strokes in Dispense mode.
v0,<value2> v0,<value2> Sets the dispense volume in strokes.
<value2>: represents a 5 digit integer
Maximum: 10,000
Minimum: 1 (default)
v1 v1,<value2> Returns the current number of strokes in Fluidic mode.
v1,<value2> v1,<value2> Sets the Fluidic mode volume in strokes.
<value2>: represents a 5 digit integer
Maximum: 60,000
Minimum: 1
Default: 100
v3 v3,<value2> Returns the Fluidic Mode isolation volume.
v3,<value2> v3,<value2> Sets the Fluidic Mode isolation volume.
<value2>:
Maximum: 60,000
Minimum: 0 (default)
w => DRAWBACK
w or w0 w0,<value2> Returns the current Drawback Volume.
w0,<value2> w0,<value2> Sets the drawback volume in strokes.
<value2>:
Maximum: 5.00
Minimum: 0.00 (default)
w1 w1,<value2> Returns the current Drawback Rate.
w1,<value2> w1,<value2> Sets the drawback rate in RPM.
<value2>:
Maximum: 1500
Minimum: 1
Default: 150
w2 w2,<value2> Returns the current Drawback Dwell.
w2,<value2> w2,<value2> Sets the drawback dwell in seconds.
<value2>:
Maximum: 2.55
Minimum: 0.00
Default: 0.05
NOTE
When using a 34 Frame Motor the minimum setting must be 0.05 or greater.
y => MOTOR/BASE
y or y0 y0,<value2> Returns the current Acceleration setting.
y0,<value2> y0,<value2> Sets the acceleration configuration.
<value2>:
0 = Slow
1 = Medium (default)
2 = Fast
3 = Fire Off
y1 y1,<value2> Returns the current Torque setting.
y1,<value2> y1,<value2> Sets the torque configuration.
<value2>:
0 = Low
1 = Medium (default)
2 = High