Need help?Do you have a question about the IVT C7 and is the answer not in the manual?
General| Heating Capacity | 7 kW |
|---|---|
| Refrigerant | R410A |
| Energy Efficiency Class (Heating) | A++ |
| Power Supply | 230V / 50Hz |
| Type | Air-to-Water Heat Pump |
Main product line identifier for the heat pump.
Specific model series covered by this installer guide.
Details the meaning of warning symbols and signal words used.
Provides essential safety guidelines for installation and maintenance.
Describes the basic characteristics of the heat pump models.
Guidance on selecting a suitable and stable location for the heat pump.
Key checks to perform before commencing the heat pump installation.
Details regarding the CAN-BUS communication system and its wiring.
Explanation of the different heating circuits and their control.
Describes how the heat pump controls heating based on sensor inputs.
Provides installation dimensions for the C6-C11 heat pump models.
Provides installation dimensions for the E6-E11 heat pump models.
Provides installation dimensions for the E14-E17 heat pump models.
Lists and illustrates the main components of the heat pump.
Details various system configurations and their explanations.
Instructions for installing and filling the collector system.
Guidance on connecting and installing the heating system components.
Procedure for flushing the heating system to ensure water quality.
Steps for installing the optional soft starter accessory.
Steps for safely connecting the heat pump to the electrical supply.
Diagrams illustrating the electrical connections and circuit boards.
Details on making external electrical connections to the control unit.
Identification and layout of the heat pump's control panel.
Explanation of the status lamp indications for operation and alarms.
Instructions for navigating and operating the control unit menus.
Procedure for accessing installer-level functions using an access code.
List of temperature sensors and their functions recognized by the control unit.
Overview of menu settings related to room temperature control.
Overview of menu settings for hot water production and management.
Overview of the various timer functions available for system operation.
Overview of menu settings for external control inputs and functions.
Detailed settings for room temperature control and heat curves.
Settings for hot water production, peak, and mode.
Configuration of various system timers and delays.
Settings for managing external inputs and their control functions.
Installer-specific settings for system configuration and operation.
Settings for the additional heat function and its parameters.
Configuration of safety functions for collector circuits and heat pump.
Overview of alarm types and their management.
Classification of alarms based on severity and impact.
Detailed description of specific alarm functions and their triggers.
Procedure to restore all settings to their factory defaults.
Lists the default factory settings for various parameters.
Factory default settings for room temperature control.
Factory default settings for hot water functions.
Factory default settings specific to the installer level.
Factory default settings for the additional heat function.
Factory default settings for safety functions.
Factory default settings for alarm behavior.
Procedure for checking the refrigerant circuit's integrity.
Guidelines for setting the correct operating pressure in the heating system.
Checking key operating temperatures after initial run.
To Next Page
