ENGLISH8 |
remote control operation
Power ON/OFF:
Press the POWER BUTTON for 1 second to POWER ON the remote control.
Press the POWER BUTTON for 3 seconds to POWER OFF the remote control.
1. Make sure both the board and the remote are OFF.
2. Hold the remote near the skateboard.
3. Press and hold the power button on the remote and the pair button on the board at the same time for 3
seconds. Both buttons will start flashing quickly. Light
1
, light
2
or lights
1
and
2
will start flashing
on the remote, depending on the selected speed mode.
4. Press and hold both buttons until the remote control beeps thrice. Once you hear the beeps, the pairing
will be complete.
Once the pairing is finished, the connection will be automatic every time the board is ON.
The board might lose the connection with the remote, especially if you are in a signal-polluted environment.
Try to pair it again if necessary. Radio frequency signals are absorbed or blocked by our bodies. Try to keep
the remote near the tail of the board, where the wireless signal receiver is built.
Try not to completely cover the remote with the hand; this can aect the wireless signal communication
between the remote and the board.
How to pair the remote control to the iWatSkate
To Next Page
Loading...