REV 7-16-201210
Operating Instructions:
• Turn toggle switch to on position when machine needs to run, and off position when finished.
• In the case of a push button kit, press push button to activate machine. It will automatically shut off.
• Remove vacuum hose from hanger and vacuum subject accordingly. Do not vacuum wet objects or fine dust
(ex – drywall dust).
• Return vacuum hose to hanger when finished.
• In the case of a dual hose model, hose claw must be returned to hanger and set against rubber pad to eliminate
leaks in vacuum system. This will allow the opposite hose to have more suction while in use.
Maintenance:
• All servicing of machine should be conducted by an authorized service representative!
• Filter bags should be accessed and shaken down weekly. It is recommended to keep a new set of bags on hand
so that once every few months the bags can be replaced and then laundered.
• To maintain performance, empty dirt bin from the canister on a regular basis.
• Periodically inspect wires and connections for wear or fatigue.
• Check vac hose for cracks on a weekly basis.
• Clean canister with a stainless steel cleaner as needed. Decals can be cleaned with mild soap and water.
• Check motor brushes approx. every 3 months for excessive wear. Motor brushes should be changed if they are
shorter than 3/8”. Please disconnect power before doing this.
DISCONNECT POWER BEFORE SERVICING OR TROUBLESHOOTING!
To Next Page
Loading...
