To Next PageTo Next Page
Need help?Do you have a question about the J.P. SELECTA UNITRONIC-ORBITAL and is the answer not in the manual?
General| Brand | J.P. SELECTA |
|---|---|
| Model | UNITRONIC-ORBITAL |
| Category | Laboratory Equipment |
| Language | English |
Lists the standard parts included with the equipment.
Details adapters and platforms for Erlenmeyer flasks.
Provides electrical and physical specifications of the baths.
Describes the general features and operation of the thermostatic baths.
Detailed specifications for the refrigerated model (Code 6001173).
Detailed specifications for the non-refrigerated model (Code 6032011).
Crucial warnings regarding electrical connection, liquid use, and safety.
Explains display indicators and basic control functions like Start/Stop.
Instructions for setting the desired temperature.
How to configure overtemperature and undertemperature alarms.
Setting max/min temp, shaking, and unit selection (°C/°F).
Controls for pausing and stopping the bath operation.
How to adjust temperature, shaking, and time while running.
Setting shaking speed and operation time.
Configuration of undertemperature and overtemperature alarms.
Procedure for calibrating the bath's temperature reading.
Setting the identification number for the serial port.
Description of overtemperature and undertemperature alarm functions.
Function and deactivation of the safety or level thermostat.
Explanation of RTD sensor errors and power failure indications.
Handling EEPROM errors and motor failure alarms.
Step-by-step guide to adjust and reset the safety thermostat.
Specific note about the heating switch for the refrigerated model.
Details on baud rate, data bits, cable length, and protocol.
How the LRC field is used to ensure data integrity.
Detailed example of how to calculate the LRC value.
Information on the type of cable required and connector pin assignments.
Commands to get and set temperature values.
Commands to control operation and identify the device.
Commands to set and read shaking speed and running time.
Commands for setting and querying temperature alarms and probe offsets.
A summary table of all RS-232 commands for reading and setting parameters.
Detailed list of alarm codes, their descriptions, and device responses.
List of electrical components used in the diagram with their codes.
The detailed wiring diagram for the refrigerated model.
Important safety steps before performing maintenance.
Recommended methods for cleaning the bath and heating element.
List of available spare parts and their corresponding codes.
Details on the product warranty and conditions.
Manufacturer's declaration of conformity with relevant directives.
Lists the specific directives and standards the equipment meets.
