Jabiru 2200 Service Manual (English)

Other manuals for Jabiru 2200

Instruction And Maintenance Manual116 pages

Overhaul Manual201 pages

Installation Manual55 pages

Questions and Answers:

T
Timothy BoyleSep 6, 2025
What to do if my Jabiru 2200 Engine runs erratically?
- S
  Stephanie ChenSep 6, 2025
  If your Jabiru Engine is running erratically or misfiring occasionally, there are a few potential causes. Start by checking the spark plugs. Clean them inside and out, adjust the electrode gap, and replace if necessary. Inspect the high tension (HT) leads; dry any damp leads and replace any that are damaged. A faulty ignition unit can also cause misfires, so consider replacing it. Ensure the fuel filter isn't clogged by renewing it. Finally, check that the carburettor sense tube is connected; this tube helps control the fuel mixture and should connect the small nipple on the carburettor to a fitting in the filtered side of the carburettor heat box.
A
Anthony ClarkeSep 5, 2025
How to fix a spark plug gap that is too large on a Jabiru 2200 Engine?
- T
  Tracy ChandlerSep 5, 2025
  If the spark plug gap is too large, adjust the gap to 0.6-0.7mm or renew the plugs.
T
Todd CamposAug 23, 2025
What to do if there's no fuel in my Jabiru 2200?
- S
  smithdavidAug 23, 2025
  If there is no fuel in the tank, refuel it.
J
John KellySep 3, 2025
What to do if spark plugs are damp due to condensation in Jabiru Engine?
- C
  Christy FergusonSep 3, 2025
  If the spark plugs are damp due to condensation, thoroughly dry both the inside and outside of the plugs.
S
Suzanne ClarkSep 2, 2025
How to fix wrongly connected high tension leads in Jabiru 2200 Engine?
- D
  Dawn RuizSep 3, 2025
  If the high tension leads are wrongly connected, connect them as shown on the leads.
M
Mark SchroederSep 2, 2025
What to do if the Jabiru 2200 Engine ignition is OFF?
- J
  Jennifer Vasquez DVMSep 2, 2025
  If the ignition is off, switch it on.
M
Marc GrahamSep 1, 2025
What causes low oil pressure in Jabiru Engine?
- J
  jfoxSep 1, 2025
  Low oil pressure in your Jabiru engine can be attributed to several factors. The oil level in the sump may be insufficient, so check and replenish as needed. High oil temperature can also lead to low pressure; ensure the engine isn't overfilled with oil and that the installation has proper gaps for adequate airflow. A faulty pressure gauge, sender, or wiring could be the culprit, requiring inspection and renewal if necessary. Faulty crankshaft bearings may also cause low oil pressure, necessitating an engine overhaul. Lastly, a relief valve that isn't sealing properly can lead to low pressure; inspect, clean, and replace it, as foreign matter stuck in the valve can cause this issue.
C
Connie MasseyAug 31, 2025
What to do if Jabiru 2200 Engine runs erratically?
- D
  Denise MatthewsAug 31, 2025
  If your Jabiru engine runs erratically or misfires occasionally, start by checking the spark plugs. Clean them inside and out, adjust the electrode gap, and renew if necessary. Next, inspect the high tension (HT) leads, drying any damp leads and renewing damaged ones. If the issue persists, the ignition unit may be faulty, requiring renewal. Additionally, a clogged fuel filter can cause these symptoms, so renew the fuel filter. Finally, ensure the carburetor sense tube is properly connected; this tube helps control the fuel mixture and connects the small nipple on the carburetor to a fitting in the filtered side of the carburetor heat box.
M
matthewevansAug 30, 2025
What to do if Jabiru 2200 runs too hot?
- R
  richardhillAug 30, 2025
  If your Jabiru engine is running too hot with the oil temperature above 110°C (230°F), there are several possible causes and solutions: * **Too much oil in crankcase:** Check the oil level and adjust if necessary. * **Low oil level:** Check the oil level and add oil if necessary. * **Poor quality oil:** Perform an oil change and use the specified oil. * **Clogged oil filter:** Change the filter. * **Excessive piston blow by:** This is commonly due to worn or sticking piston rings, which may require a complete engine overhaul. * **Faulty bearings:** If metallic particles are present in the oil, a complete engine overhaul is necessary. * **Faulty oil temperature gauge:** Exchange the gauge.
J
jimenezbrandonAug 27, 2025
Why is my Jabiru Engine running too hot?
- E
  Eric CastilloAug 28, 2025
  If your Jabiru Engine runs too hot, with oil temperature above 110°C (230°F), there are several possible causes. Check the oil level; too much or too little oil in the crankcase can cause overheating, so adjust as necessary. Poor quality oil can also lead to this issue, so consider an oil change using the specified oil. A clogged oil filter restricts oil flow, so change the filter. Excessive piston blow-by, often due to worn or sticking piston rings, may require a complete engine overhaul. Faulty bearings can also contribute to overheating; if metallic particles are present in the oil, a complete engine overhaul is necessary. Lastly, a faulty oil temperature gauge can give a false reading, so consider exchanging the gauge.

Jabiru 2200 Specifications

General

Compression Ratio	8.0:1
Fuel System	Carbureted
Oil System	Wet sump
Displacement	2200 cc
Power Output	80 hp
Stroke	74 mm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Type	Four-cylinder, four-stroke horizontally opposed air-cooled engine
Weight	61 kg (134 lb)

Related product manuals

Jabiru 3300

103 pages

Jabiru 2200 Maintenance Manual

Table of Contents

Other manuals for Jabiru 2200

Questions and Answers:

Jabiru 2200 Specifications

Related product manuals