Need help?Do you have a question about the jablotron TD-101 and is the answer not in the manual?
General| Brand | jablotron |
|---|---|
| Model | TD-101 |
| Category | Telephone Accessories |
| Language | English |
Overview of potential applications and use cases for the dialer.
Details the purpose and connection of each terminal on the dialer.
Explains the dialer's actions upon receiving a trigger signal.
Illustrates various ways to connect trigger inputs IN1 and IN2 to the dialer.
Describes how to configure the dialer for emergency calls for individuals.
Steps to access and enter the user mode for programming.
Guide on entering phone numbers for voice message delivery.
Instructions for recording voice messages to be sent by the dialer.
How to input phone numbers and data for pager message transmission.
Procedure to remove stored telephone numbers from the dialer.
Instructions for teaching the dialer to recognize remote control signals.
Method to clear all learned remote control codes from the device.
How to test if voice and pager messages are sent correctly.
Steps to modify the user access code for security.
Procedure to reset the dialer to factory defaults in case of issues.
Accessing the installer mode to configure monitoring station communication.
Inputting phone numbers for the monitoring station.
Removing stored monitoring station phone numbers.
Selecting communication protocols and data formats for the monitoring station.
Entering the account number for monitoring station communication.
Setting up specific codes for reporting dialer input events.
Performing tests to verify communication with the monitoring station.
Accessing installer mode for advanced feature configuration.
Setting the maximum number of attempts to contact the monitoring station.
Enabling or disabling the dialer's detection of telephone line signals.
Controlling the built-in speaker for audible monitoring of dialer functions.
Enabling or disabling the ability to stop dialing with the End key.
Selecting between pulse or tone dialing methods.
Choosing to use one 20-second or two 10-second voice messages.
Setting the logic (NO/NC) for the IN1 and IN2 trigger inputs.
Programming a delay before the dialer reacts to trigger inputs.
Configuring the number of times messages are sent to phone numbers.
Enabling or disabling the emergency trigger function via the Fce key.
Modifying the installer access code for security purposes.
Setting the pause duration when dialing pager numbers.
To Next Page