Telephone dialer TD-101 / TD-101W - 8 - MDJ512 10 Telephone dialer TD-101 / TD-101W - 17 - MDJ512 10
6.8. Testing the message sending
Sending of voice & Pager messages can be tested in the user mode (the green LED is ON - see
6.1.), entering:
FM
E
where:
E
is the tel. number memory 1 to 6 in which the corresponding message will be sent. If you
enter 0 all tel. numbers will be tested. Testing is always audible (you can hear tel. line
signals and voice messages from the built in speaker).
Example : Voice message no. 1 will be sent to tel. number Mem2 :
FM
6.9. Changing of the User Code
To avoid non authorized access to the user mode, change the User Code for a new one. The code
can be changed in the user mode (the green LED is ON - see 6.1.), entering:
M
DDDDDDDD
where :
DDDD
is your new user code (four digits). The new code must be entered twice to be changed
(protection of accidental change). Original factory default setting of the User Code is 1234.
Example : The user code will be changed for code 2010 :
M
To Next Page
Loading...
Need help?
General