S5 Workshop Manual Engine
8) Install cylinder protective cover, and
apply oil onto the shown position.
Tightening torque
Rocker arm cover bolt: 8 ～ 10 N•m
Center cover bolt: 4 ～ 5 N•m
Sealant
A position: Threebond No.10 or
equivalent
B position: Threebond No.1212D or
equivalent
9) Install spark plug and ignition coil.
Connect secondary guide wire, and then
install protective cover plate.
10). After installing camshaft position
sensor signal wheel on the rear of exhaust
camshaft, install rear cover and sensor of
camshaft.
Cylinder head
protective cover
To Next Page
Loading...
