S5 Workshop Manual Engine
■ If there is a groove to place sealant, please put the sealant into this groove.
■ For bolt holes, generally apply sealant into the holes. Sometimes, apply sealant
outside of the hole.
■ Install binding parts within 5mins after applying sealant.
■ If there is dirt on the sealant, immediately clean it.
■ Do not re-tighten locking bolts or nuts after installation.
■ After 30 mins of installation, refill engine oil and engine coolant.
■ If there is special instruction in this manual.
To Next Page
Loading...
