12 / 51
图 5-6 Figure 5-6
注意：为了防止机器突然启动造成人身事故，请关掉电源，确认电机确实停止转
动后再进行操作！
Note：In order to prevent the machine from personal accident suddenly,
please turn off the power supply, confirm the motor really stop running
again then operate !
5、压脚压力调节 Adjust presser foot pressure
请把压脚压力在缝迹稳定范围内尽量调弱
调节压脚压力时，拧松压脚调节螺母，并将压脚调节螺杆顺时针或逆时针旋转，顺
时针旋转则压脚压力变大，逆时针旋转，则压脚压力变小。
It should be as light as possible, yet be sufficient to obtain the proper
stitch formation.
When adjust pressure for presser foot ,loosen adjusting screw presser
foot , and make presser foot adjusting screw clockwise or counterclockwise
To Next Page
Loading...
