Jack k4 Series - Safety Switch Adjustment; Safety Switch and Solenoid Valve Clearance

49 / 51
图20
十、安全开关的调整
调节安全开关与电磁阀间隙，安全开关与电磁阀间隙为0.5mm，可通过松开紧定螺
钉上下调节安全开关与电磁阀的间隙，知道安全开关灯亮为止，然后拧紧紧定螺钉
（图21）
Fourth, the safety switch adjustment
Adjust the clearance between the safety switch and the solenoid valve. The
clearance between the safety switch and the solenoid valve is 0.5mm. Adjust
the clearance between the safety switch and the solenoid valve by loosening
the set screw. Until the safety switch is on and tighten the set screw (Figure
21)