10 QUALITY OF CUT
en-81
10.9 RIFLING OR TRAMLINING __________________________________________________
NOTE: Arrow indicates direction of travel.
Rifling or tramlining is a pattern of different cutting heights
that gives the grass an appearance like a wave. This
appearance is normally caused by heavy contact points
across a reel and bedknife.
Probable Cause Remedy
The reel is damaged or is not worn equally. Check and adjust the HOC on cutting units to same
height.
Loose, missing or over-torqued bedknife screws Install, replace or tighten the bedknife screws to the
correct torque.
Cut (ground) speed is higher than normal Reduce the cut (ground) speed.
To Next Page
Loading...
Need help?
General
