MAINTENANCE AND LUBRICATION 8
en-62
8.7 HYDRAULIC FILTER _______________________________________________________
The hydraulic system is protected by one 10 micron filter. A 25 psi (1.7 BAR) visual
indicator (A) is on the side of the filter head to indicate when service is needed.
When you replace the filter:
a Fill the new filter with hydraulic fluid and lubricate the filter O-ring with
hydraulic fluid before you install the new filter. Tighten the filter with your
hand.
b Operate the engine at idle speed for five minutes to remove the air from
the hydraulic system.
c Stop the engine and check the level of hydraulic fluid in the tank. Add the
hydraulic fluid to the Full mark on the dipstick.
CAUTION
Hydraulic oil can damage your skin. Use gloves when you use hydraulic oil. If hydraulic oil touches your skin,
clean the area immediately.
CAUTION
Discard used hydraulic oil in accordance with local safety regulations.
A
To Next Page
Loading...
Need help?
General
