14
CHAPTER 1 - PRECAUTIONS
J-600 ELECTRIC
Safety guidelines
∙ Keepastepandhandrailalwaysclean;oiland
grease can cause accidents.
∙ Donot useequipment if there is repair need
in some key components. Make the repair
prevously.
∙ This equipment can cause accidents if used
inept or irresponsabily.
∙ Donothoponthemachinewhenit’smoving.
∙ Before initiate the tranport, it’s important that the
track where the equipment will be transported be
carefully studied and that the regulator body that
regulates this type of transport be contacted about
the law and legislation current.
∙ All freeways, roads and streets that have utilization
caracteristics for utilization that are influenced by
natural’s factors (clime, growing of a tree without
mankind interference, etc.) and construction (used
material, bridges height, electric post, lane width,
etc). These caracteristics must be carefuly valued
before the equipment tranportation.
∙Incasedoubt,do not make the transport. Con-
tract a specific company for this type of job.
∙ Be sure that the chemical circuit was rinse and
the tank is totally empty after rinse. The checmical
leaking, as minimum it can be, may risk put in risk
people’s life, animals, envirolment.
∙ Wash ouside the equipment after it’s use. Even
it looks clean, tje strps used to hold the equipment
must not be reused to hold food, the straps may be
polluted and pollute it.
∙ During the equipment strap process, make use
EPIs. If necessary, make a combination of the re-
quired EPIs during the equipment load (i.e.: safety
boots, gloves, helmets, etc.) with EPIs required for
the chemical application. This combination will
minimize the contamination risk.
∙ The equipment hold on the truck or trailer must
be done by the tires and by the specific points (see
illustration below). The hold must be made safety,
since it can cause serious accident’s risk.
> Safety recommendations for transport
To Next Page
Loading...
Need help?
General
