Need help?Do you have a question about the Jacuzzi Energy and is the answer not in the manual?
General| Jets | 40 |
|---|---|
| Voltage | 240V |
| Amperage | 50A |
| Shell Material | Acrylic |
| Cabinet Material | Synthetic |
| Warranty | 5 years |
Ensure product integrity upon receipt and check for visible damage to packaging.
Verify that all pre-installation arrangements comply with manual instructions.
Inspect for defects by removing protective film; installation voids warranty for impact/abrasion damage.
Ensure all clamps holding rubber couplings and air lines are tightly fastened.
Advice on installing bath against finished walls/floors, panel access, and aeration requirements.
Caution that water system pressure must not exceed 600 kPa (6 bar).
Requirement to install DB type protection unit for drainage columns, minimum 15 cm above tub edge.
Illustrates different permissible installation types for the bath.
Depicts optional components and configurations for bath installation.
Shows initial steps for handling the bath, including lifting and positioning.
Details the process of assembling and adjusting the bath legs and supports.
Illustrates the connection of water supply, drainage, and air lines.
Shows the installation of jet covers, bezels, and other bath components.
Illustrates the electrical hookup for the whirlpool system.
Guides on filling the bath and performing initial operational tests.
Details connecting to L and N terminals for 220-240V supply from two-phase systems.
Illustrates different methods for installing side panels based on bath placement.
Shows specific methods for securing and adjusting bath panels.
Demonstrates how to install panels at bath corners, including cleaning precautions.
Details the installation of a full front panel, including cutting and fixing methods.
Illustrates installing the bath within a larger enclosure, including panel placement and fixing.
Shows how to apply finishing strips to the edges of installed panels.
To Next Page
