Need help?Do you have a question about the Jacuzzi LCD Series and is the answer not in the manual?
General| Category | Hot Tub |
|---|---|
| Shell Material | Acrylic |
| Series | LCD |
| Lighting | LED |
| Control Panel | LCD |
| Insulation | Full Foam |
Safety instructions specific to CSA standards for electrical equipment.
Information on hyperthermia, its causes, symptoms, and effects in spa use.
General cautions for spa use, including health conditions and supervision.
General electrical safety instructions for spa installation and operation.
Power requirements for J-350, J-360, J-370 models in USA/Canada (60Hz).
Power requirements for J-380 models in USA/Canada (60Hz).
Power requirements for J-350, J-360, J-370 export models (50Hz).
Power requirements for J-380 export models (50Hz).
Instructions for permanent wiring, dedicated circuits, and wire types for spa installation.
Requirements for GFCI protection and proper grounding for spa electrical connections.
Detailed instructions on cleaning and maintaining spa filter cartridges.
Interpreting common display messages like OH, COOL, FLO*, etc.
Diagnosing issues based on error codes like PAL, WATCHDOG, SN1, FLO2.
Procedures for no operation, pump issues, poor jet action, and priming.
Steps to resolve issues with water being too hot or no heat being produced.
To Next Page