J-100
Decontamination Procedure (Steps 9-16)
Steps 9-16 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.
Refer to the table below for approximate water ll volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash,
and void the manufacturer warranty for your spa.
!
Water Fill Volume by Model
Model Average Fill Volume* Sodium Dichlor
J-145 360 Gal (1,363 L) 9.0 oz
J-135 360 Gal (1,363 L) 9.0 oz
*Use average ll volume for chemical maintenance
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
pillows and plastic knobs from chemical attack. If spa
is indoors, open doors and windows for proper
ventilation. Turn on all jet pumps for one hour, then
open all air controls.
Note: You will need to press the jets pump button(s) every
20 minutes since these functions have an automatic 20 minute time-out
function that turns them off.
WARNING: RISK OF PERSONAL INJURY!
• To decrease the risk of injury, drowning or entrapment,
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small
children and animals!
• Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in Section 12.2 “Draining and Relling” (page 27).
12. Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. DO NOT OVERFILL.
Air Control
18
To Next Page
Loading...
Need help?
General
