J-200 Series
Decontamination Procedure (Steps 9-16)
Steps 9-16 below are only required when sanitizer levels are unstable after per-
forming steps 1-6 above. Disregard steps 9-16 below if sanitizer levels remain
stable at 3.0-4.0 ppm chlorine or 2.0-4.0 ppm bromine after performing steps
1-6.
9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water. Refer to
the table below for approximate water fill volume by model.
CAUTION: Never add chlorine tablets (trichlor) to your spa for any
reason! This chemical may damage your spa and void the manufac-
turer warranty.
Water Fill Volume by Model
Spa Model Approximate Fill Volume Sodium Dichlor
J-270 & J-280 390 US Gallons (1,476 Liters) 10.0 oz
J-230 380 US Gallons (1,438 Liters) 9.5 oz
J-220 335 US Gallons (1,438 Liters) 8.5 oz
J-210 220 US Gallons (1,438 Liters) 5.5 oz
10.
Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting pil-
lows and plastic knobs from chemical attack. If spa is
indoors, open doors and windows for proper ventila-
tion. Turn on all jet pumps for one hour, then place
the massage selector knob in the center “combo”
position and open all air controls (J-210 models: Turn
Diverter Jet in the “combo” position). Note: You will
need to press the jets pump button(s) every 20 minutes
since these functions have an automatic 20 minute
time-out function that turns them off.
CAUTION: Never leave your spa unattended for any reason while
the cover is open and accessible to small children and animals!
11. Turn off power to the spa at the circuit breaker, then drain spa as outlined
in section 12.2 “Draining And Refilling” (page 30).
12. Fill spa until water covers all jets but does not touch the bottom of the low-
est headrest. DO NOT OVERFILL.
Set all air controls to
their full open
counterclockwise position
Massage Selector
A
B
C
Set all air controls to
their full open
counterclockwise position
Massage Selector
A
B
C
18
To Next Page
Loading...
Need help?
General