J-200 Series
periods of severe freezing temperatures, it is important that all water be removed
from the spa and equipment to protect against damage from freezing. For
expert winterization of your spa, contact your authorized Jacuzzi dealer. In
emergency situations, damage can be minimized by taking the following steps:
Follow the directions on page 30 for draining the spa.
As the water level drops below the seats, use whatever means necessary to
get the water out of the recessed seating areas and into the foot well.
When the water level ceases to drop, use whatever means available to
remove any remaining water from the foot well.
Turn off power to the spa.
Remove the synthetic cabinet panel under the control panel and locate the
drain plugs on the front of the pump(s), (Figure-A, page 14). Remove plugs
to allow water to drain out of pumps and heater. Note: Approximately one
to two gallons will be released during this procedure. Use a wet/dry vacuum
or other means to keep this from flooding the equipment compartment.
Replace the drain plugs.
Re-install synthetic cabinet side panel and cover spa so that no casual mois-
ture can enter into it.
Consult your authorized Jacuzzi dealer if you have any questions regarding
winter use or winterizing.
12.8 Restarting Your Spa in Cold Weather
If you want to start up your spa after it has sat empty for a time in freezing
temperatures, be aware that the water remaining in certain sections of the piping
may still be frozen. This situation will block water flow preventing the spa from
operating properly and possibly damaging the equipment. We recommend you
consult your authorized Jacuzzi dealer for guidance before attempting to re-start
your spa under these conditions.
1.
2.
3.
4.
5.
6.
32
To Next Page
Loading...
Need help?
General