Jacuzzi J - LXL User Manual

36
LX Collection
An optional chemical feeder is available through your
authorized Jacuzzi dealer that installs under the lter cap
(#2472-673). Always remove the chemical feeder cap and
feeder (when used) during the lter cleaning process by
turning the cap handle counterclockwise. Reinstall the
cap and feeder back onto the lter cartridge after the lter
cleaning process is complete. It is recommended that latex
gloves be used to avoid touching the chemical feeder
during the lter cleaning process.
Note: When used, the chemical feeder MUST remain on the circulation
pump lter cartridge! This lter cartridge is the one with the grid across
the wall tting as shown (right).
TO DECREASE RISK OF DEATH, DROWNING
OR ENTRAPMENT, ALWAYS TURN POWER
TO SPA OFF BEFORE CLEANING THE FILTER
CARTRIDGES!
Note: Refer to steps below and on the following page
for complete lter cleaning/replacement instructions.
A
DANGER: TURN POWER TO SPA OFF! TO DECREASE
RISK OF DEATH, DROWNING, OR ENTRAPMENT, NEVER
OPERATE SPA WHEN FILTER IS NOT PROPERLY INSTALLED
OR IF SKIMMER ASSEMBLY IS DAMAGED OR ALTERED!
B
(Spa Shell)
Tilt cover forward to
access lter cartridges.
(The skim shield is
connected by spring
clips, use caution so the
lid does not snap back.)
C
Remove skimmer bag
and lter skimmer from
clips, then clean out
debris. Replace the lter
skimmer about every
three months, depending
on spa use.
D
Rotate each lter
cartridge handle
counterclockwise to
unthread from mating
wall tting.
Filter
Skimmer
Skimmer
Bag

Jacuzzi J - LXL Specifications

General

Brand	Jacuzzi
Model	J - LXL
Category	Hot Tub
Language	English