19
Slow random transition
The change from one colour to another takes place slowly and with
no pre-set order.
First rapid random transition
This colour cycle is similar to the previous one, except for the fact
that the changeover from one colour to the next takes place about
three time faster that the previous one.
Second rapid random transition
Similar to the previous, but with a range of shades between blue
and green.
Steady colours
The following seven colours can also be selected and displayed
steady: white, pink, lavender, light blue, dark blue, light green and
dark green.
Water ltering
F
iltering, obtained through the combined action of a pump and
a cartridge lter, is indispensable to keep the water clean and
transparent, and to eliminate particles in suspension.
N.B.: some models are equipped with an ozone generator (ozona-
tor, optional) which helps disinfect and purify the water. When the
ltering cycle is started, the generator starts automatically, and
shuts o at the end of the cycle.
X The ozonator runs automatically and is contingent on the ac-
tivation of the pump (at low speed) during the ltering cycle. It
will be o if the hydromassage or even one spotlight is on. This
is because there is probably a person in the tub. Forty (40) minutes
after the functions are shut o , the ozonator begins operating
again, provided a ltering cycle is active.
Setting the ltering cycles
To set the ltering cycle:
X Press the “Light” key and hold it down for about 5 sec-
onds. The display will show the message dx, where “x” indicates
the duration in hours.
X Use the key “Up/Down” to enter the desired duration,
from a minimum of 0 to a maximum of 12 hours.
NOTE: hold the key down until you reach the desired value.
If the display is equipped with two separate keys, press the key
“Up” to increase the value or the key “Down” to decrease it.
X Press the “Light”
key once again to con rm the selected
value and to continue the programming of the start delay, com-
pared to time “0”, of the cycle (parameter sy, where “y” indicates
the number of hours).
ATTENTION: the “0” time is the instant in which the spa is powered
using the main switch. If, for example, the cycle start delay is set to “4”,
this means that ltration will start 4 hours after the spa is turned on.
X Set the start delay (from a minimum of 9 to a maximum of 23)
using the key “Up/Down” and con rm using the “Light”
key to save the entered value and exit from the programming
mode.
When this function is active, the LED of the respective symbol
will turn on. If the LED is blinking, it means that the cycle has been
suspended, see the relative chapter for more information.
“Boost”
This special type of ltering is recommended in special situations,
such as before or after a party with friends, or to facilitate dissolu-
tion of substances used for water disinfection.
X To activate this function, press and hold down the “Pump”
key for 5 seconds. The display will show the message boo.
X This function lasts 45 minutes (this value cannot be modi ed)
during which the pump is run at high speed, at the same time as
the ozonator.
For details on ltering, refer to the product’s installation
manual.
To Next Page
Loading...
Need help?
General
