22
Setting the hours and minutes
Pull crown B out to position 2.
The movement will be stopped. This will in turn stop the seconds hand. Move the
hands clockwise until the desired time is displayed.
Once the operation is complete, push the crown back into position 1. The watch
will start running again.
Setting the alarm
Winding
Crown A in position 1.
The alarm is wound by turning the crown clockwise. When winding is complete,
the crown is locked.
Setting the alarm time
Pull crown A out to position 2.
This function enables you to adjust the alarm’s mobile disc by turning the crown
anti-clockwise to position the triangular mark situated in the centre of the dial
opposite the desired alarm time.
Once the operation is complete, push crown A back into position 1.
Starting and stopping the alarm
The alarm is activated when crown A is in position 1. It is stopped when the
crown is in position 2.
The alarm can be stopped at any time by pulling out crown A. However, note that
it is essential to push the crown back into position 1 to ensure water-resistance.
MASTER MEMOVOX INTERNATIONAL
The Master Memovox International features a disc that displays the time in
24 cities around the world. The disc is divided into 12 segments, each containing
2 cities whose time zones are 12 hours apart. The cities situated on the outside
of the disc are 12 hours ahead of those located on the inside. This system ena-
bles simultaneous day/night readings worldwide.
To Next Page
Loading...
Need help?
General
